Magnetek Flex 12RS System Informações Técnicas descarregar pdf (Página 34)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 34 of 49

4.10 DIGITAL INPUT MODULE – GEN 2

This section is applicable to the following digital input part number(s):

 198-80104-DNPT1

The Flex M Digital Input module allows the reading of eight digital signals. Each of the digital inputs can

be configured for a range of 4-36V (Low Range) or 36V-240V (High Range) operation for either AC or DC

voltages via a manual jumper connection. Refer to Figure 33 for jumper locations and settings.

The input reference voltage is not supplied by the card. Figure 34 shows the wiring for the module. For

each input pair, one input is used for the reference and the other input is used for the input to be read.

The digital input module number is set by the rotary switch located on the lower left corner of the board.

Figure 33. GEN2 Digital Input Module Detail View

Figure 34. GEN2 Digital Input Module Wiring

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 48 49

Sem comentários

Magnetek Flex 12RS System Informações Técnicas Página 34