Magnetek Flex 12RS System Informações Técnicas descarregar pdf (Página 13)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 13 of 49

9. Position the receiver; make sure to locate it as far as possible from exposed trolley wire and

sources of electromagnetic or radiated noise.

10. Mount the receiver. Refer to Section 3.8 for further information regarding mounting.

11. Wire the unit using the electrical drawings provided with the system. Each section for the

modules also indicates how the module should be wired.

12. Wire the power input for the input power type as described in Sections 4.3 and 4.4.

13. Wiring of the system should now be complete. Install the antenna.

14. If there are any problems, refer to Section 9.

3.8 REMOVAL

1. To remove modules from the rail for service, first ensure all power to the Flex M modules has

been turned off and proper lockout/tagout procedures have been followed.

2. Remove one end rail clamp and un-nest the module that you wish to remove by separating it from

the others on the rail.

3. Use a slotted screwdriver to lift the DIN rail release tab on the top of the module. Swing the

module down and away from the top tab/ring and unhook from the rail.

4. The PCB from any module can be removed from its housing by pressing in both tabs first (tabs

are on the front and back sides of the housing); then the top housing and PCB can be removed

from the lower housing (see figure below for details).

Figure 2. Flex M Housing Removal Detail

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 48 49

Sem comentários

Magnetek Flex 12RS System Informações Técnicas Página 13