Magnetek Flex 12RS System Informações Técnicas descarregar pdf (Página 23)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 23 of 49

4.4.1 POWER SUPPLY LED OPERATION

When the Flex M system has power supplied, the two LEDs on the power supply module should be lit and

solid.

Figure 17. GEN2 Power Supply Module LED Placement

 +5VDC CPU

o Indicates that +5VDC power is going to the CPU

 +5VDC RELAY

o Indicates that +5VDC power is going to the RELAY modules

4.5 RELAY MODULE – GEN 1

This section is applicable to the following relay module part number(s):

 25-02-074-805E

The Flex M Relay module allows the control of high current power (up to 5A) for attached equipment

through 8 relay outputs. Four relays have a common power input and four relays have individually

separate power inputs. The relay module number is set by the rotary switch located on the lower left

corner of the board.

Relays are rated for 10 Amps 277VAC/30VDC, 1 HP 240VAC, but fused for 5A. External suppression for

the relays is needed.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 48 49

Sem comentários

Magnetek Flex 12RS System Informações Técnicas Página 23