Magnetek Flex 12RS System Informações Técnicas descarregar pdf (Página 15)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 15 of 49

4. FLEX M MODULES

The Flex M system comprises of a RF/CPU module and a power supply module with application specific

add-on cards in between the CPU module and power supply module.

During the operation of the receiver, the LED indicators will allow observation of the status of each of the

modules of the Flex M receiver. Refer to each of the sections below for specific information regarding

each of the modules. Be sure to reference the correct part number for each module type as some of the

modules have different versions.

4.1 RF/CPU MODULE – GEN 1

This section is applicable to the following RF/CPU module part number(s):

 25-02-074-800E (900MHz Part 15)

 25-02-074-801E (400MHz Legacy Communication)

 25-02-074-807E (900MHz 1W) – No longer available

 25-02-074-815E (900MHz 200mW) – No longer available

 25-02-074-816E (433MHz Part 15)

 25-02-074-818E (2.4GHz 50mW)

 25-02-074-819E (2.4GHz 125mW)

 25-02-074-821E (400-420MHz)

 25-02-074-822E (410-430MHz)

NOTE: The high power RF/CPU Module 25-02-074-807E draws up to 1300mA of power when in use. It

requires high current power supply module 25-02-074-810E to perform properly.

The Flex RF/CPU Module is the main module that receives radio signals from a paired transmitter and

interprets those signals into the appropriate response for the attached I/O modules. There is one RF/CPU

module in the Flex M System.

Figure 4. GEN1 RF/CPU Module Detail View

(For all RF/CPU modules except 900MHz 1W (25-02-074-807E) & 900MHz 200mW (25-02-074-815E))

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 48 49

Sem comentários

Magnetek Flex 12RS System Informações Técnicas Página 15