Magnetek Flex 12RS System Informações Técnicas descarregar pdf (Página 20)

Flex M Engineered Receiver Instruction Manual

October 2014

Page 20 of 49

4.3 POWER SUPPLY MODULE – GEN 1

This section is applicable to the following power supply module part number(s):

 25-02-074-804E (120VAC 15VA, 1000mA)

 25-02-074-810E (9-18VDC @1.5A 25VA, 1500mA) – No longer available

 25-02-074-820E (9-36VDC 15VA, 1000mA)

The Flex M power supply module converts the supply power to 5VDC power for all the attached Flex M

modules. This power module has a maximum output supply current of 1000mA. There is one power

supply module in the Flex M system.

Figure 10. GEN1 Power Supply Module Detail View

Figure 11. GEN1 Power Supply VAC Wiring Figure 12. GEN1 Power Supply VDC Wiring

NOTES:

1. Although the power module has built-in protection, Magnetek strongly recommends the use of

external fuses and circuit disconnects for all Flex modules.

2. The built-in fuse is not user serviceable but can be checked if troubleshooting. To check the

fuse, remove the power module from the din rail as described in Section 3.8. The fuse location is

shown in Figure 10. Use a multimeter to check for continuity across the fuse. If the fuse is

blown, contact Magnetek to send the module in for service.

3. The total system current consumption should not exceed the maximum output supply current of

the power supply module. If additional supply current is required, contact the factory for a custom

solution.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 48 49

Sem comentários

Magnetek Flex 12RS System Informações Técnicas Página 20