Magnetek Flex 12RS System Manual de Instruções descarregar pdf (Página 37)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 37 of 42

11. TROUBLESHOOTING

WARNING

THE OPERATOR SHOULD NOT ATTEMPT TO REPAIR ANY RADIO CONTROLLER. IF ANY PRODUCT

PERFORMANCE OR SAFETY CONCERNS ARE OBSERVED, THE EQUIPMENT SHOULD IMMEDIATELY BE

TAKEN OUT OF SERVICE AND BE REPORTED TO THE SUPERVISOR. DAMAGED AND INOPERABLE RADIO

CONTROLLER EQUIPMENT SHOULD BE RETURNED TO MAGNETEK FOR EVALUATION AND REPAIR.

FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO

EQUIPMENT.

11.1. TRANSMITTER STATUS LIGHT INDICATORS & WARNINGS

Type Display Type Indication

Slow green blink

(Normal Operation)

Transmitter on and in standby.

2 Blinking orange

Button has been pressed and the unit is transmitting.

The speed at which the orange LED blinks is directly

related to how far down the button is pressed.

1 red blink followed by a

2-second pause

Voltage goes below 1.9V during operation -

change batteries immediately.

2 red blinks followed by a

2-second pause

A push button is active while turning on the transmitter.

The button that is active will be designated by the (A, B

25, 100) LEDs. See Push Button Error Table below.

3 red blinks followed by a

2-second pause

I-CHIP error.

4 red blinks followed by a

2-second pause

Transmitting error, system cannot lock on

to the designated channel.

Constant green for up to 2

seconds

Transmitter power on with no faults detected (prior to

initiating the START function).

8 Solid Red

Stop command initiated with receiver

ESTOP deactivated.

9 Solid Red

Voltage goes below 1.9V at initial power on -

transmitter

power shuts off.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

Comentários a estes Manuais

Sem comentários

Magnetek Flex 12RS System Manual de Instruções Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Magnetek Flex 12RS System