Magnetek Flex 12RS System Manual de Instruções descarregar pdf (Página 19)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 19 of 42

6. OPERATING PROCEDURE

6.1. GENERAL OPERATING PROCEDURE

1. Reset the red emergency stop button located on the top left hand side of the transmitter handset

by rotating it either clockwise or counter clockwise. The red button will pop up.

Figure 11

2. Turn on the transmitter power by inserting the black-colored key into the power key slot located

on the top right hand side of the transmitter handset and rotate it clockwise to the “On” position.

Figure 12 Figure 13

3. After turning on the transmitter power, check the Status LED on the transmitter handset for any

sign of system irregularities (refer to Section 11.1). If the system is normal the Status LED will light up

green for two (2) seconds, then slowly flash green.

4. If there are no signs of any system irregularities, then rotate the power key further clockwise to

the “Start” position for up to 2 seconds. This will activate the receiver E-Stop. Thereafter, the same “Start”

position will become an auxiliary function with momentary contact.

Figure 14

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Sem comentários

Magnetek Flex 12RS System Manual de Instruções Página 19