Magnetek Flex 12RS System Manual de Instruções descarregar pdf (Página 35)

Flex 4EX System Instruction Manual

December 2012

32 of 39

1. For best reception the location of the receiver should be visible to the operator at all time.

2. The location selected should not be exposed to high levels of electric noise. Mounting the

receiver next to an unshielded variable frequency drive may cause minor interference. Always

locate the receiver as far away from the variable frequency drive as possible.

3. Ensure the selected location has adequate space to accommodate the receiver (refer to Fig.

18 on page 31).

4. For better reception, make sure the receiver is in an upright position.

5. Drill one hole (8mm in diameter) on the control panel or location where the receiver is to be

installed (refer to Fig. 18 on page 31).

6. Make sure the bolt is tightened after installation.

7. For system wiring please refer to page 30.

6.4 SYSTEM TESTING

1. Turn on the power source to the receiver and test the MAIN relay output by pressing the red

emergency stop button and observe that it properly opens and closes the mainline disconnect

contactor.

2. Test the operation of each function to ensure it corresponds to the transmitter direction labels or

the pendant it is replacing.

3. Test the limit switches (if any) to see if they are working properly.

4. If your new remote control is replacing an existing pendant, make sure it is completely

disconnected and placed in a safe location to prevent unwanted control commands.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42

Sem comentários

Magnetek Flex 12RS System Manual de Instruções Página 35