Magnetek Flex 12RS System Manual de Instruções descarregar pdf (Página 26)

Flex 4EX System Instruction Manual

December 2012

23 of 39

OFF

3rd

SPEED

4.2.2.5 Magnet ON/OFF Push Button Function

The user can set any of the two adjacent push buttons on the transmitter to control a

magnet. To activate the magnet just press the push button with the Magnet symbol. To

deactivate the magnet, for safety purpose, you must first press and hold the Magnet

push button and then press the OFF push button. Pressing the OFF push button by

itself can not deactivate the magnet (refer to page 25 on how to set to this function).

4.2.2.6 Brake Function

When the transmitter push button is released from 2

speed up to 1

speed, both 1

and

speed output relays will open for up to 1.0 second and then with 1

speed output

relay closed thereafter (refer to page 25 on how to set to this function).

4.2.2.7 Momentary Contact

When the push button is released, the output relay that corresponds to that push

button will open (refer to page 26 on how to set to this function). This type of contact is

usually applied to external application such as horns or buzzers.

4.2.2.8 Toggled Contact

When the push button is released, the output relay that corresponds to that push button

will remain closed (maintained contact) until next time the user presses the same push

button again (refer to page 26 on how to set to this function). This type of contact is

usually applied to external application such as lights.

4.2.2.9 3

Speed Push Button Function

This function allows the crane to travel an additional step beyond 2

speed. For

example, if the operator is pressing the “UP” push button down to 2

speed, pressing the

speed push button (with “UP” push button still being held at 2

speed) will toggle

between 2

speed and 3

speed (refer to page 26 on how to set to this function).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

Sem comentários

Magnetek Flex 12RS System Manual de Instruções Página 26