Magnetek Enrange CAN-6 Manual de Instruções descarregar pdf (Página 38)

Flex 8EX System Instruction Manual

December 2013

Page 38 of 44

7. OPERATING PROCEDURE

7.1 TRANSMITTER OPERATION

7.1.1 General Operating Procedure

a. Reset the red emergency stop button located on the top left hand side of the transmitter

handset by rotating it either clockwise or counter clockwise. The red button will pop up.

b. Turn on the transmitter power by inserting the black-colored key into the power key slot

(located on the top right hand side of the transmitter handset) and rotate it clockwise to

the “On” position.

c. After turning on the transmitter power, check the Status LED on the transmitter handset for

any sign of system irregularities (refer to “Status Light Indicators & Warnings” on page 41).

If the system is normal, the Status LED will light up green for two (2) seconds.

d. If there are no signs of any system irregularities, then rotate the power key further

clockwise to “Start” position for up to 2 seconds - this will activate the receiver MAIN

(depends on JP3 setting on page 32). Thereafter, the same “Start” position will become

an auxiliary function with momentary contact (refer to page 28).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Sem comentários

Magnetek Enrange CAN-6 Manual de Instruções Página 38